Tor R's latest activity
-
Tor R replied to the thread Not so pros 4 new and without politics or drama.Good morning girls & gays -
Tor R reacted to Kiwioilboiler's post in the thread Not so pros 4 new and without politics or drama with
Like.
From the D Handle do I take it that it has a ported 288 as a powerplant? Or just that you are a big fan of the D...😏 -
Tor R reacted to JoeDirt's post in the thread Not so pros 4 new and without politics or drama with Like.
Evening gents. I picked up this snowf#cker on Facebook marketplace for $200 to get through the big storm. Needed a bit a fiddling but I...
-
Tor R reacted to cuinrearview's post in the thread Not so pros 4 new and without politics or drama with Like.
See. You get it
-
Tor R reacted to Kiwioilboiler's post in the thread Not so pros 4 new and without politics or drama with Like.
Is there enough for both time slots?
-
Tor R reacted to cuinrearview's post in the thread Not so pros 4 new and without politics or drama with
Haha.
Just asked with a straight face in my kitchen: "cheesecake now, or later?" -
If I don't get a dyno run on 32:1 e-free and olive oil I'm out of here.
-
I didn’t get a chance today. I ended up putting the van in the shop for a clogged catalytic. I’m hoping to run it at sea level. The...
-
What size middle aged lesbian? I got a 4’ large mount Stihl in .404…may slap that on give it a rip.
-
Tor R reacted to huskihl's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
There are a lot of members that enjoy messing around with it. Good for the soul, creating something usable and watching your progress as...
-
Tor R reacted to Lawless's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
I have a guide that rides on a 2x6 to try and I plan to buy an adjustable one that rides on rails or a ladder. I want to make a few...
-
Tor R reacted to huskihl's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
Other than the side plate staying sharp a little longer being at 80°, yes. Standard chain works fine for milling, noodling, or cross cutting
-
Tor R reacted to Junk Meister's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
Bob L has/had a many page thread over on AS one comment was kind of an answer. Don't waste a chain away by sharpening it all at...
-
Tor R reacted to Philbert's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
I often set my depth gauges with the grinder, for height, then round them over to the factory profile using a ScotchBrite deburring...
-
Tor R reacted to Philbert's post in the thread Chainsaw grinder questions, tips, tricks, and pics!!!! with Like.
Some guys mentioned, over the years, profiling their depth gauge grinding wheel concave, to adjust height, and shape them, at the same...