STOVE's latest activity
-
STOVE replied to the thread My 290-390 conversion thread.This is the Initial run, idle was running wild and both screws around 2 out Here is the tune as of this evening. What sounds should I... -
STOVE replied to the thread My 290-390 conversion thread.Finally getting the idle and low jet dialed in. Carb tuning is not my strong suit. Need to find some decent wood to get it in for a high...
-
-
STOVE replied to the thread My 290-390 conversion thread.The contact spring was bent, had a big bow in it that was allowing the end to dip lower than it should. Got the saw cranked. Will do...
-
STOVE replied to the thread My 290-390 conversion thread.Cannot for the life of me figure out the contact spring. If I pull the trigger and push the lever to the full choke position it slips...
-
-
STOVE replied to the thread My 290-390 conversion thread.We have a chainsaw. A few things that were boogerbears in the assembly. The ring compresssor tool works well. The AV rubber grommet...
-
-
STOVE replied to the thread Recent Wood Score Post your Pics Thread.Brought home some old dried out poplar, and some stinky spalted maple. One tiny little row of red oak under the poplar
-
-
STOVE replied to the thread My 290-390 conversion thread.I used the Herman layout for the holes in the face. I also have the stock deflector with th port opened slightly. Can try both. I’m sure...
-
STOVE replied to the thread My 290-390 conversion thread.Stihl waiting on my 1127 ring compressor tool, however a coworker gave welding on the deflector a go. Looks like it will let some air out
-
-
STOVE replied to the thread My 290-390 conversion thread.1127-893-2602 Mine is still in the mail somewhere
-
-
STOVE replied to the thread My 290-390 conversion thread.Still waiting on my 1127 ring compressor to arrive and I had a thought. I’m constantly running my fingers over the inside of the ports...
-
-
STOVE replied to the thread My 290-390 conversion thread.No, I looked it up. It’s a black Stihl branded one specifically for these clamshells
-
STOVE replied to the thread My 290-390 conversion thread.Got the exhaust done tonight, tried my best not to touch the op or bottom much if at all. Then came the big hang up. I cannot get this...
-
-
STOVE replied to the thread My 290-390 conversion thread.Took the leap tonight into grinding the jug. Fell asleep in my daughter’s room putting her down. Walked downstairs around 11:20. Phone...
-
