Steve's latest activity
-
Got the center seat/console, doors and fenders swapped over. Plus, because I'm still an adolescent I just had to thrash the donor truck... -
I looked at this truck on Monday for a no start. The rear crossmember went to chow town on the fuel pump module wiring. I had looked at...
-
It's got exhaust.
-
Right side tailpipe happening.
-
And a cold start, idle sound clip
-
Left side tailpipe getting done..
-
The factory trans dipstick tube I cut down was functional but made contact with the firewall. Bought a Lokar firewall mount one and...
-
I'll most likely order a few more bends I don't have and work on getting some tailpipes on it seeing it willbe some time before the...
-
Chevelle transmission part 2, take 173,890. New converter should stall 2200-2500ish. Back in.. I had run ran straight pipe to the...
-
The boiler is installed, gas hooked up, and the building is now heated via radiant heat in the floor. Since so much time had passed...
-
Cleaned up the carbs on the wood hauler. Far as i can tell, they haven't been touched in the 26 yrs/7000 miles this machine has been...
-
I am dealing with a blown head gasket right now, its filling at least one cylinder with coolant where the truck won't idle, but will...
-
Great engines! The stroke is longer than the bore diameter(designed for immediate torque). Loaded with a cord of green wood in the...
-
Steve replied to the thread Grease Monkey Garage.Looks good Ed!
-
Sea backs and sill plates on.
