srcarr52's latest activity
-
500i from last week -
Back on track 572 Not really artwork, it’s just one I did today
-
srcarr52 replied to the thread WANTED Husqvarna 385 or 395 throttle shaft.I had one AM 395 carb that required some drilling of the low speed circuit to get it to run right. It was always lean at idle no matter...
-
srcarr52 replied to the thread WANTED Husqvarna 385 or 395 throttle shaft.Are you looking to fit a bigger carb in the Dolmar 9000? Because those intake boots are pretty restrictive.
-
no mods but she doesn't really require any.
-
srcarr52 replied to the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets.I modify the original arm and then make a few components for it all to work. Probably around $250 with return shipping.
-
srcarr52 reacted to Sawdust Man's post in the thread how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread? with
Like.
. Evening. Just beautiful weather! 👍 Tom and I made trusses at the stamp today....all built and ready for installation next time around. -
srcarr52 replied to the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets.Yup, I can modify those old Simington 450's so they have a vertical and horizontal adjustment.
-
-
srcarr52 reacted to huskihl's post in the thread Simington / Silvey Square Chain Grinders Tips/Tricks/Secrets with Like.
I believe Shaun makes an adjustable arm for it, but it’s been a while, could be wrong on that one. You can also shim your wheel down to...
-
srcarr52 replied to the thread Wiseco Pistons from CCC Racing.There are almost no non chrome ring options in the 1mm thickness. Replacement chrome rings can be ordered directly from Wiseco...
-
srcarr52 replied to the thread Builder’s favorite build?.Yes, mainly the coil but the autotune seems to start to add fuel right around the rpm limit.
-
srcarr52 replied to the thread Builder’s favorite build?.The autotune and the limited coil on the Husky 592 hold it back tremendously.
-
srcarr52 replied to the thread Builder’s favorite build?.It's probably obvious but it's the Husky 395 for me.
-
srcarr52 reacted to Homelite410's post in the thread how about a Oklahoma,AR,MO,KS,TX,+IA GTG thread? with Like.
Good morning gents! Been a hot minute since i stopped in to say hi! Hope all is well fellas, burning ash here and some oak in the shop.
-
I forgot to take a picture of the milled hex. :confused: Dolmar 420/460/4k/5k/6100 clutch removal tool. Impact drive proof...
