Sloughfoot's latest activity
-
Not a 400 but hf foam catch’s everything! Nothing getting through, so winning I guess… -
Yep in production work I use a 60cc after a top handle about half the time, depending on the job. If the drop zone is big enough I’ll...
-
Played with the new $74 shoebox size, amazon flux core welder. Very surprised at what it could do without any wire speed control...
-
I went out and rode around the mountains
-
Sloughfoot replied to the thread So what did you do today?.Wanted it to stay put till the back cut was done and only smash the old rotten shed roof a little so I hooked the all purpose vehicle up...
-
-
-
Installed the extended wear kit on my winter work gloves ….. Stuck a good sharp skip chain on the 066 ….. I hauled a few large...
-
Actually did some wood cutting 😳 Took a 10' Ash stump down for a guy. Almost got it in 1 load...almost. Creative rigging to pull it...
-
I went through 5 tanks to find one that did not leak. I cleaned the others up and am giving them the Red Kote treatment now. I had...
-
-
Here is the muffler baffle. I still feel it helps to stop a short circuit out of the deflector. Any saw I’ve done where u can check...
-
I relieved the AF holder so that any spitback could get sucked into the strato’s. Seems to make a difference on the Dyno I’ve been...
-
Milled some weeping birch for my buddy. Beautiful piece with spalting, interesting grain patterns. Used the 394xp, which pulled the 50”...
-
I think im finally starting to get the hang of this.
-
Pickled carrots and eggs.
