Sloughfoot's latest activity
-
Sloughfoot replied to the thread Chain gauge.Finding any variety of chain you want won't be a problem with .050 for the length of bar you're running. Options will be limited with... -
If your pulling the jug back off, I'd be checking it for out of round or taper as well. Can probably use the ring at various points down...
-
.004” per bore inch i think? so .010-.011 is what id shoot for
-
I'm gonna suggest a vacuum\pressure test Tom. If this saw ain't got a strong impulse signal, it ain't gonna run. That divot at the port...
-
I’ve had strange results lately with compression on both a 272 and an 064. Turned out with both of them that the ring gap was too big...
-
Does it feel like 110? If so try the tester on another saw. I've had the shrader valves get sticky/dirty. When that is the case they...
-
Yes, that will reduce the compression. Does it have a base gasket in? The next question is what compression gauge are you using? One...
-
this is saw with flat back carburetor, ran nice on idol...
-
But where's the sticker?...lol
-
THE one saw plan right here
-
Sloughfoot reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with
Like.
Yes, this particular saw is a 1225. Mark -
I haven't looked at this 444SG - 1984, for 6-8 years, figured I'd do what I was planning to do at the time. Now it got a new oem fuel...
-
PHO= power head only
-
Sloughfoot replied to the thread MCCULLOCH The official McCulloch thread.Is this McCulloch's first?
-
Sloughfoot reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
The transmission (gear box) is back together. I've been looking into McCulloch two man saws... 1225 1948-1948 7.9 In3 5-49...