Recent content by singinwoodwackr

Yes. What all do you need?

Have any of the 372xp ? I got 2 recently that turned out to be xt so won’t work. They were mis labeled…

I have all the parts for 066s and a few 660 housings (they are wider). If the trigger parts are all the same I have everything. Try listing the exact pt#s you need and I can see what all I have.

Dang…$120 for a new can? I think I paid $35 for the pair I have…not each, for the pair. The Scepter cans look good, never tried those. Nozzle is about the same cost as the nato.

I haven’t looked in years. They used to be common at surplus stores

Too pretty…Stihl will steal your design 🤣

We do have expensive hobbies :p

Surplus NATO 20L cans

yea, by the time you add the 6%tx... I feel bad for other states with higher rates

I think I has ordered a couple of the OE ones to try and you are right, poor quality.

New ones here with that combo are $2k 😳

That looks great. Any pics of just the components? My 577 could use that mod. If anyone needs one of the mesh filters for these saws, I have a couple bags of nos . oops, the bags full are for the 5/6-series, older saws...575, 695, etc. I do have extra ones for the 577/757, just not a bunch of...

Might be a tad high without a wrap handle.

Aftermarket, I wonder if they are any good. HL has oe but they are out of stock.

372xp build for a friend...ground-up. Runs and cuts great. Blue, limited coil, tachs to 13+. But...comp is only 155. This was an experiment with the Duke's hard-chrome topend. Sq is .032 even with BGD so... Minor porting consisted of widening the exhaust port, widening the transfers at the base...