singinwoodwackr's latest activity
-
Ssinginwoodwackr reacted to Stihlcutting's post in the thread HELP! Stihl 020av fuel seepage around the fuel tank gasket. with
Like.
Thank you for your response. I will try the lapping of the half. I may have a piece of machined flat stock handy to use. As for the... -
Ssinginwoodwackr replied to the thread Husky 572 vs 585.Well...it's a 5-series...so...
-
Ssinginwoodwackr replied to the thread SOLD Husqvarna 41.So…I clean it up, do some porting, MM, etc and send it up to you?…for $150 🤣 Well, assuming I don’t just keep it…
-
SThank you!!! Thank you!!! Thank you!!!
-
Ssinginwoodwackr replied to the thread SOLD Husqvarna 41.I’ll take it
-
SHusqvarna 41 powerhead only runs, but could use the carburetor cleaned and or adjusted and might have an air leak. $60 plus shipping? Or...
-
Ssinginwoodwackr replied to the thread STIHL The Official Stihl Chainsaws Thread.check for air leak...pressure/vac test...and probably rebuild the carb.
-
Ssinginwoodwackr reacted to Partner's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Carburetor adjustment or left air leakage into the engine
-
Sits is probably something super simple that just got missed.
-
SGuess I somewhat resemble that. When someone says make an offer I didn't think you were supposed to start out high and work your way...
-
SAny petroleum product will soften it slightly but its the abrasive that does the work. A piece of thin card stock can be shaped into a...
-
Ssinginwoodwackr replied to the thread So what did you buy today.60g? 🤣
-
Ssinginwoodwackr replied to the thread Husqvarna 3-Series lot build.It did loosen it up a bit. But, the bead blast only took a few seconds…done. Stuffed a paper towel in the cyl and cleaned out the...
-
SThat's why I said 250, didn't figure I'd be out anything lol. Glad you got it sold, I really like mine, I should probably get it out...
-
SAll I can remember is that you liked it when JJ sent you dick pix.
