singinwoodwackr's latest activity
-
SI straightened a 7900 one after pressing in a new bearing and then welded the pin as well. Actually done it 3 times now none have...
-
STwo V blocks and a dial indicator will show you the truth. I had to check a solo 681 crank after I welded the pin.
-
SIn this particular case I’m not sure, but it’s very common for the crankweights on the lobes to not be lined up perfectly. If you look...
-
SSmokin’ deal! Although it looks damn cold there in the background.
-
SNew in box. DOM 5-25 . $1050.00 Plus Shipping. Lower 48 only. I have bars available for extra. Depending on what length you want...
-
Ssinginwoodwackr replied to the thread What's on your bench?.No air leaks before you tore it down?
-
SFollow up: The owner of this saw said it was running erratically a few weeks back. Compression tested good, pressure and vacuum good...
-
Ssinginwoodwackr replied to the thread What's on your bench?.
-
-
Ssinginwoodwackr replied to the thread So what did you buy today.Like I needed another saw...sigh...🙄 It'll clean up nicely. 36" light bar, .063, in good shape. No piston wear top to bottom but it...
-
-
SThere is 14 cases haven't gotten a chance to look over it yet
-
S346 and 350 part saws...
-
Ssinginwoodwackr reacted to TheDarkLordChinChin's post in the thread So what did you buy today with
Like.
Haven't used the 372 with the stihl bar yet but my 562 and 394 both oil fine with stihl bars -
SMy first guess would be start capacitor, as already mentioned. Cheaper than a motor!
-
Ssinginwoodwackr reacted to MtnHaul's post in the thread Loose oil adjustment screw on 046--won't hold position. with Like.
I'm pretty sure I found the proper HO pump at 1128 640 3250
