singinwoodwackr's latest activity
-
SThey are $500+ new. Anyone have a used one?
-
Ssinginwoodwackr replied to the thread NSFW 3/4” pitch, Harvester chain grinder.I think the 530 will work. I could justify buying one to replace the cheap Vevor I use for rakers now. I’m doing 3-4 3/4” chains a week...
-
Ssinginwoodwackr replied to the thread NSFW 3/4” pitch, Harvester chain grinder.Lol
-
Ssinginwoodwackr reacted to lehman live edge slab's post in the thread Post up your ported cylinder Artwork with
Like.
Don’t worry I’m done, I’ll post some pictures of one I’m done and he can post whatever he likes. Was just trying to help like the whole... -
Ssinginwoodwackr reacted to EFSM's post in the thread Post up your ported cylinder Artwork with Like.
I wish you two would knock it off. Maybe you could PM each other with your grievances; or maybe that wouldn’t be as much fun.
-
Ssinginwoodwackr reacted to lehman live edge slab's post in the thread Post up your ported cylinder Artwork with Like.
See here’s the thin skin again
-
Ssinginwoodwackr reacted to lehman live edge slab's post in the thread Post up your ported cylinder Artwork with Like.
That’s good was just trying to help and the whole reason to post on here is to get feedback both good and bad along with ideas from...
-
Ssinginwoodwackr replied to the thread NSFW 3/4” pitch, Harvester chain grinder.I haven’t searched that hard for used yet but I’d imagine there are some out there. These are $2k which is way more than I can justify...
-
Ssinginwoodwackr replied to the thread Show me your Knifes.@Hdtoolmkr765 on AS
-
Ssinginwoodwackr replied to the thread WANTED Ms441 handlebar.Will older 1128s fit? Oops, not even close :p
-
SUpdate the intake boot clamp to metal if it does not already have.
-
SWell, you sorta get what you pay for… Chinese being cheapest and OEM being better and more expensive. You might get away with just a...
-
SYes, worth repairing! If you pull the cylinder off and check, you might be surprised, there might be minimal damage if any on the...
-
Ssinginwoodwackr replied to the thread impossible to download manual.Here’s one
-
Ssinginwoodwackr reacted to legdelimber's post in the thread Post up your ported cylinder Artwork with Like.
Like Lehman says, it adds up. We always figured about .017 per inch of distance, for one degree out of square. I milled tapered bars...