SimonHS's latest activity
-
Because, at the end of the day, no matter all the circumstances of the moment, it's your name attached to the job in perpetuity. So... -
He should just cut a hole in the gasket and give it back to the owner as ported (needing re-tuning after porting job) . 😅 I imagine the...
-
Idk I told him that. I held up my timing wheel and said I can't get readings without the case, crank and piston. I'm just gonna widen...
-
That would be the Chusqvarna 543xp. They’re different
-
Ummm???? I said hold up! Wait a minute! Something ain't right! how do be Stratto ports receive air?
-
Shop is full this week. I was using the Struck to move fill sand into the site for the new building and the spiral retaining rings for...
-
The muffler and air filter can be installed in China, but the cylinder cover must be ordered, although it is far away 😉8
-
McCulloch 4 HP air cooled outboard motor. Same basic engine block as the 80cc chainsaws. I also ordered a few small items (o-rings...
-
Too big for a bench, drug this junk out and started cleaning it up for summer.
-
This one came in this week, would not start. Remarkably, the spark arrester screen was quite clear. Mark
-
SimonHS reacted to Czed's post in the thread Any Chinese chainsaw and chinese parts discussion with
Like.
Runs good I didn't even tune it -
45cc Chinese girl ready to have fun 😉 Although the piston doesn't look good, if it falls apart, I have a second dose 🤠👍
-
A nice black Emak spool 12 years old and 2 Chinese ones. The orange one is new and the fuel lines have arrived / The chain is probably...
-
SimonHS reacted to Czed's post in the thread Any Chinese chainsaw and chinese parts discussion with Like.
I ordered one of these to try.
