Shane¹'s latest activity
-
SCan’t. The lathe stays outside of it
-
SHow do you do it? Flat file by hand? Belt sander, lol?
-
STiny pointed and/or flat burs. It’s not crazy important to have it perfect, it just can’t be high. I try to make certain I’m at least...
-
SThank you Kev. I will show pictures of it relieved as I go forward. Time has been the biggest hindrance for me. Hoping to get final...
-
SXS in Euc, twice as hard as oak. 20” 23rsp
-
SStill working on these things…. Going for 105 ex 122 uppers 78 intake Hands have been feeling bad lately and I’m concerned I’ll f...
-
SToday I installed my last two parts for a Husky 365 that I bought from @redneckhillbilly (great guy to buy from!!). This was a fun...
-
SI replaced the throttle assembly with a nos after noticing the thing was not quite getting to full throttle. Got a few hundred more rpms...
-
SIf Meteor 242 piston is used it becomes a low compression turtle, with the same intake timing as the old 42 had. On Gilardoni 241 C or...
-
SWith your new throttle assembly, are you getting full speed? I've seen new ones that didn't make it...
-
SWith the new assembly the throttle opened fully. Not that it was a big amount in the first place…It hit 14,3 briefly after playing with...
-
SShane¹ replied to the thread What's on your bench?.Parts for this cream sickle showed up so got the bottom end together and started putting it back together
-
-
SWell damn, It finally happened. I got scammed through Facebook…. I’m pretty sure it was a real person, we talked on the phone. Went...
-
SAlso, check to make sure your bolts are clamping down on the flanges properly. Sometimes the bolt holes are a tad shallow and the bolts...
-
SIn theory, you could make a base piece that had a cutter mounted. You can definitely modify the cutter for other chamber contours. If...
