Shane¹'s latest activity
-
SSo… which one? @heimannm
-
SJonsereds 920.
-
SDefinitely in for a set eventually 😀
-
Spop rivet and redkote?
-
SDrill and tap. 1/8” pipe plug should work as long as it’s thick enough. Install with red locktite or maybe epoxy. I remember @Stump Shot...
-
SIt will work as long as the area involved has a little bit of "meat" to it to make a couple few threads. Being a tank and not a...
-
SLooks complete I have sets of dawgs for these if you need them. Details in the 2100 thread…
-
SI bought another saw today that will consume my time finding parts. It sounded mean with a shot of gas in the spark plug hole though.
-
SIs that a 2100 or one of the smaller variants? Yeah, parts are fun to find, post what you need, never know who has what!
-
SI have fixed a couple of holes in tanks using JB Weld applied from the outside only. Just make sure it's roughed up a little, is clean...
-
SI was cleaning up my Homelite 450 project when I noticed a screw in the bottom of the case. I unscrewed it and gas started pouring out...
-
SWith the possible white death corrosion looking at other areas in the picture, you may have to JB weld and use a tank liner like POR-15...
-
SShining a flashlight into the tank, there is luckily no corrosion inside of the tank. There is just a very minimal amount on the bottom...
-
SI am not that familiar with that saw and looking at the IPL didn't help either, I can't tell if the fuel tank/ bar oil tank come apart...
-
SThe other thing I was thinking about is some sort of nut/bolt combo with rubber washers on either side.
