Shane¹'s latest activity
-
SWith that you risk having something sticking out and potentially catching on something. One thing you could do is put some JB weld on...
-
SI would think if pressed in fuel lines and tank vents don't leak then a tight fitting low profile rubber plug you could drill the tank...
-
SShane¹ replied to the thread Fixing hole in tank.I would thread it with an 1/8 inch pipe tap then screw a brass plug in with loctite on it until it tightens up then grind the outside flat.
-
STOTAL BARS AND DOLMAR SPROCKETS HAVE BEEN SOLD.
-
SI am getting ready to start a 290-390 conversion. The Dukes cylinder that showed up has a few things that need to be addressed...
-
SPhotos of cylinder
-
SI'm glad you asked about the finger nail files, I had a thought about using those as well but didnt know where/when to ask. I am curious...
-
SI would think it would be too easy to take too big of a bit with a file than it would be to use a Dremel or other spinny tool. Might be...
-
SThat lip is likely the cylinder plating intruding into the port. Some people have had trouble with the plating peeling off after...
-
SSanding Twigs, 20-Pack | Rockler Woodworking and Hardware https://share.google/Ut8UnZREp9TRXLBux Lumberton Sanding Detailer Kit -...
-
SNail Files? I've grabbed the metal ones at a Dollar store and used them to touch up kitchen knifes, rough edges on drinking glasses...
-
SI've used small diamond file sets that have different curvy shapes to take plating ridges off ports and chamfer the port edges. I've...
-
SI have been doing LOTS of reading on here and AS in prep for this build. @Mastermind has a great thread on this and I am going to use...
-
SAlso any muffler mod photos would be appreciated. Trying to brainstorm removing the inner baffles
-
SContinuing my prep for this conversion. I put a piece of cardstock in the jug and traced the existing ports for size and shape. Exhaust...
