Shane¹'s latest activity
-
SOn the last one I did you are right, .017 with base gasket delete.
-
SGot this 7310 as a project saw. Got it rebuilt and put back together nicely. New bearings, seals, caber ring, oil gear etc. Runs and...
-
-
SPicked this dolmar 460 up when I picked that 350 and 510 up a while back. Finally got around to getting a clutch cover for it. Had some...
-
-
SAnyone want to buy an 056AV Super off me to help fund this purchase? 🤪
-
SWeekend special $350.00 plus shipping cost ttt
-
SWhy hasn’t someone scooped this up yet? I said I wasn’t going to buy another one of these…
-
SI should have picked this up on Wednesday when I drove right by the Belleville exit.
-
SOn the 350’s, doing a gasket delete almost always yields perfect squish clearance, so I’m not sure why you would do this.
-
SI do not have a mill, but I can get what ever squish I want with those bearing blocks by using 80 grit wet r dry on a flat surface &...
-
SI have tried it and there are small gains, but not worth it in my opinion. It is hard to raise the transfers enough and still aim them...
-
SShane¹ replied to the thread SOLD Dolmar 6800.This one is spoken for 👍
-
SShane¹ replied to the thread Husqvarna 350 build thread.What about doing machine work on the 350 cylinder? Do you think it is worth the extra work or not?
-
SProbably another 20% if using a 44.3mm top end.
-
SShane¹ replied to the thread Husqvarna 350 build thread.@farminkarman how much do you think full machine work and port work would gain over the mild porting you plan to do on this one?
-
SI have not had any of those come loose. (4 of em) By this I mean I have not had a 357-359 come loose without the support.
