Shane¹'s latest activity
-
SYes, I recommend this approach on those too.
-
SCan this be used on 357 359 ? part number is 588775502
-
SThanks for the add on the different thread types. Any of the AM risers I have gotten are based off the latest design with the M5...
-
SGreat thread. I know of at least three bearing cups. The oldest had coursed threads on the cylinder and the crankcase screws. Then came...
-
SOne of my favorite 350 mods using a part that I stole from a 353 and mounted on a 350 with muff mounts that kept loosening up. I cut off...
-
SYep, I do that too!
-
SAgree. A set of name brand bearings is dirt cheap.
-
SShane¹ replied to the thread Husqvarna 350 build thread.I personally would want to use a good new bearing with an aftermarket seal over a crunchy old oem bearing out of a part saw. If the...
-
SGood callout on the AM parts thing and the slip fit of the bearings on the crank.
-
SIf it was mentioned I missed it. Does a 351 case fit into this equation?
-
S351 is basically a 353 with a 44mm top end. Open transfers. Magnesium case. If we're bringing up Jonsered, it would be a 2149
-
SThis feels like a good time to bring up: using aftermarket parts in this bottom end setup can really shake up a build. I've never...
-
SA few weeks ago I had some visitors, AJ, Thomas, and James Wolthuis (Alan's sons)...they left this PM6 with me, NOS but a broken...
-
SPerfect timing for this thread to come up! Last cutting season my 350 developed an air leak. I shut it down and put on the shelf. I need...
-
SI like your approach to this Greg. I know your a busier family man now. But, this site has needed some professional builder input for...
