Shane¹'s latest activity
-
SMitch Weber stopped by today, he's in the process of reworking his shop and needed to get some stuff out of the way. I think I can...
-
SAdded some bling in the shop, Titan sign courtesy of Max. Mark
-
SAlright gang, sounds like there is enough interest in a thread on building husky 350's and their related plastic-cased variants (Husky...
-
SThe first problem area on these saws that I want to cover is the intake boot clamp. Husky for some reason decided to use an integral...
-
SThe next problem spot I want to address (only applies to saws with the cylinder riser) is the cylinder riser. On every single 350 I...
-
SThe last big problem area for these saws is the mufflers rattling themselves loose. On some saws this led to exhaust gases burning a...
-
SIf you are just interested in getting a 350 back up and running well in a stock configuration, addressing the three issues above should...
-
SThere are many different ways to do a muffler mod on these and results may vary depending on what other modifications you do along with...
-
Splaceholder
-
Splaceholder
-
Splaceholder
-
SDid you by any chance, take pics of what you did on the transfer dividers? I've got a couple 353 cylinders id like to experiment with.
-
SI happened to compare a 350 to a 353-cylinder one time and what I noticed most was the upper transfers were much smaller in the 350...
-
SI can take a pic of that. I noticed it helped when doing 350/346 builds. Not sure if it is really needed with the 350 cylinder.
-
SThat is the approach I’m going to take. No machine work on this one, but I’m doing to work the transfers a bit and widen the exhaust...
