Shane¹'s latest activity
-
SYeah, I got a couple of them too, they are light & a joy to run.
-
SI had a concrete walkway at my old house 100’ long or more that was almost perfectly flat. I’d buy cull lumber and lay it on the...
-
SShane¹ reacted to Wilhelm's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with
Like.
Huh! I never new the 6100 had two chain tensioner options: - 130-213-150 , Pro - 130-213-160 , Pro-Long -
SShane¹ reacted to Wilhelm's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
I may still try run her WOT, short burst, without the muffler. Let her warm up with muffler on though. Use really good ear protection if...
-
SShane¹ reacted to ErnieG's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Mufflers wide open ...I checked that a few times to be sure . Ernie
-
SShane¹ replied to the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread.Worth checking for sure I had a 9000 through me for a loop with a plug muffler took me a bit to figure out that one
-
SGreg did a 346 NE for me and it’s a monster! Love that saw
-
SShane¹ replied to the thread Sealant or not?.I like to use a thin layer of gasket maker on case gaskets. Usually loctite 5920 copper because I get it free from work. Use dirko on...
-
SShane¹ replied to the thread Question about crank case seals during reassembly after splitting a case - Dolmar 6421.I like using a plastic McDonald's cup for putting seals in they are so thin and work great but the flywheel side has a good taper I...
-
SShane¹ reacted to huskihl's post in the thread Question about crank case seals during reassembly after splitting a case - Dolmar 6421 with Like.
Like mentioned, the flywheel side isn’t so bad. And some clutch sides aren’t bad, depending on how the crank is designed. If there is a...
-
SShane¹ replied to the thread Question about crank case seals during reassembly after splitting a case - Dolmar 6421.Flywheel side usually goes together really easy. Maybe the slightest amount of heat with a heat gun but I bet you will find flywheel...
-
SShane¹ reacted to sevensandeights's post in the thread Question about crank case seals during reassembly after splitting a case - Dolmar 6421 with Like.
Good advice - thanks! Do you recommend anything for getting the cases back together when just the flywheel side of the crank needs to...
-
SMan, I want it bad
-
SMore pics
-
SI hate to do it, but selling my old school muscle. 2101xp with working chain brake. Appears all OEM. Runs, oils and idles as should...