Shane¹'s latest activity
-
SI ordered that a couple of days ago and didn't really notice the full description until today. Tried contacting the seller, but ebay is...
-
SThis is about the same delivered cost as the ebay one: https://www.partswarehouse.com/Husqvarna-Cylinder-HUS-544142908-p/HUS-544142908.htm
-
SShane¹ replied to the thread WANTED 346xp Cylinder 44.3 mm NE.Yeah it is probably fine
-
SThe picture and part number are correct.
-
SShane¹ replied to the thread WANTED 346xp Cylinder 44.3 mm NE.I was iffy on that one because his description is weird and says 50-not 44.3
-
SI think this is the cheapest thing going...
-
SFlex test
-
SShane¹ replied to the thread What's on your bench?.I have some miscellaneous 394 parts kicking around when you get to that one
-
SAs promised, I snagged these 254 and 394 carcasses, plus a 372 cylinder and carb, for $100 from a local saw shop. The 394 has a full...
-
SPicked this saw a while back. It was too good of a deal to pass up. But I could use the money to fund some other projects. All OEM...
-
-
SHeck, these days the clutch cover will set you back a couple hundred. Nice looking saw, GLWS!
-
SJust put a few nicer parts on this tonight ready to go to a new home. Runs oils and cuts as it should. Has a hyway piston and...
-
-
SShane¹ replied to the thread What's on your bench?.Swapped some parts around and made this saw even nicer
-
-
SShane¹ reacted to Gavinmalloy18's post in the thread FOUND IT Makita/dolmar 6400/7900 stock with
Like.
Looking for any of these saws in stock form in good running shape. Thanks -
SYou need a 390, a 395 and a 3120.
