Shane¹'s latest activity
-
SWhat I actually think I need is a 254 and a 394. And I just so happen to know where two carcasses are sitting that I’m going to buy next...
-
SI have a stock dukes on a 350 I built running strong through 8 tanks or so.
-
SI think I’m becoming a Husqvarna man… 288, 345, 350, 359, 372, 55, 242, and 266 in the picture.
-
SToss it in a lake. If it's bad it will sink. If it's good it will float. Least that's what Dallas told me.
-
SShane¹ reacted to old_sir_henry's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with
Like.
Piston rings, piston and cylinder are also failure prone on these due the extremely dusty conditions they worked in. The Wacker BTS-11... -
SShane¹ reacted to mgr1's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Check the crankshaft/conrod before searching parts to convert it. Most of this bts 11 have a bosh ignition with limiter.
-
SShane¹ reacted to FederalQ's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
He would like to convert it, but the list of parts needed and availability may nix that. I am sure it would need an oil pump, clutch...
-
SShane¹ replied to the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread.That is a yellow dolmar 309. Are you going to convert it over to a chainsaw or keep it as a chopsaw?
-
SShane¹ reacted to heimannm's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
The city Superintendent brought is a similar saw a few years ago. They use it for cutting frozen turf when preparing a grave site in...
-
SShane¹ reacted to FederalQ's post in the thread DOLMAR/MAKITA The Official Sachs Dolmar Dolmar Makita Dolmar Chainsaws Thread with Like.
Looks like a Dolmar with a Bavarian twist. A buddy of mine picked this up recently. The tag under the clutch cover is blank with the...
-
SI updated the post with what they are. Squish band cutters from Joe.
-
SDidn't buy them today. But, they just showed up. Squish band cutters from @Red97
-
SHL Supply just got some back in stock last week. New Edition 44.3mm 346XP OEM Husqvarna cylinder kits. I have one on the way as of...
-
SI think people are seeing the three series stuff going NLA and holding on to their junk.
-
SAlso looking for a new one, but here in Europe they wanna have 370 to 400 € for a new one.