Scott Kelsey's latest activity
-
SDrywall is all hung, crew will be coming back to tape and finish. Carpenter has been working on getting the exterior work done...
-
SDrywall installation started today. Mark
-
SDrywall arrived on Friday. Mark
-
SWhile I'm waiting for the paint to cure on the Clinton 424 project, I decided to give this Dayton 2Z462A (Poulan 306A) a good cleaning...
-
SScott Kelsey reacted to Al Smith's post in the thread MCCULLOCH The official McCulloch thread with
Like.
I found the two spline sockets plus the wrench plus a spline screw .Where that second socket came from I have not a clue .I also found... -
SScott Kelsey reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
The spline socket is 85584, there is also a "L" shaped wrench PN 85583. Vintage Vixen was selling the "L" wrenches again recently...
-
SScott Kelsey replied to the thread MCCULLOCH The official McCulloch thread.Does anyone know of a source for the special socket/splined Mcculloch connecting rod bolts?
-
SScott Kelsey reacted to jacob j.'s post in the thread MCCULLOCH The official McCulloch thread with Like.
If your airbox is filling with fuel, then it's likely the inlet needle not closing. It could be that the inlet needle lever isn't...
-
SScott Kelsey reacted to jacob j.'s post in the thread MCCULLOCH The official McCulloch thread with Like.
Heck yeah Mr. D - awesome!
-
SScott Kelsey reacted to Woodslasher's post in the thread MCCULLOCH The official McCulloch thread with Like.
Only 3 years after I got it, I finally got the clutch lapped to the crank and put my CP125 in some wood. It still needs to be tuned just...
-
SHi everyone. Looking for a few parts for a Mcculloch 797. I am in need of the following parts in good used condition or NOS. Part...
-
-
SScott Kelsey replied to the thread MCCULLOCH The official McCulloch thread.Mark, thank you very much. This is extremely helpful. I will read your link this evening.
-
SScott Kelsey replied to the thread MCCULLOCH The official McCulloch thread.Wondering what you guys can tell me about this 797 carburetor. I believe it is a Mcculloch flatback? From old threads I have read...
-
-
SScott Kelsey reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Scott, I would normally start with 1-1/14 turns open on both H &L. The fact that it starts with throttle and no choke would indicate...
-
SScott Kelsey replied to the thread MCCULLOCH The official McCulloch thread.
