High Quality Chainsaw Bars Husqvarna Toys

Recent content by sawracr

  1. S

    SELLING 680 solo parts

    Parts gone
  2. S

    SELLING 680 solo parts

    190. Shipped lower 48 last chance.
  3. S

    SELLING 680 solo parts

    If you need the parts this could be what you need, great crank and clutch, great tank, very good starter, good top cover, with a few parts could put this one together.
  4. S

    Wicked 090

    *b-worden looking 084 does it require a piston with a smaller pin, or is it a MC piston?
  5. S

    288XP CRANKSHAFT HELP

    Sounds like bearings are binding, take a dead blow hammer and rap on both crank ends until crank frees up.
  6. S

    2100 husqvarna

    I could use 2 stock bore.
  7. S

    Hey Dave, Jon Rupley here I'am looking for 090 race Pistons got any or know where I could get some?

    Hey Dave, Jon Rupley here I'am looking for 090 race Pistons got any or know where I could get some?
  8. S

    Saw building numbers.

    OK OK now you know how hard it is to get info, understand there is a lot to building a race saw (I.E. Port placement, boost ports, cylinder head, squish, ignition timing, lightning of rotating mass, blown down, ect.) with that being said everyone needs to scratch around with a dremel some...
  9. S

    3120 cylinder

    I have a 3120 cylinder, condition very poor, needs to be bored or rebuilt, my question any value?
  10. S

    Cho90

    Been there done that, must have been early small pulley.
  11. S

    FOUND IT Roller nose bar

    2 7/8 roller 40" 46 full length should be worth 150.
  12. S

    FOUND IT Roller nose bar

  13. S

    FOUND IT Roller nose bar

    Get you some pictures tomorrow, if things workout we could meet some where in between . I live in Eldorado co.
  14. S

    FOUND IT Roller nose bar

    I have a 40 " 46 overall has a homelite pioneer mount ( will also fit husky) if your interested.
Top