Recent content by sawnami

Picked up a folding drag saw. Around 1915 vintage. Also got a Mono 7-20 that has a AH-81(131cc) Power Products engine and a Pioneer 1073.

The Ford chainsaw is a runner. Someone had apparently been into the carburetor and lost the needle valve lever spring and replaced it with what they thought would be an equivalent. Over 40 lb of pressure would not pop the needle valve off its seat.

That's important information to know. Mark. I do have an IPL but that's not to say that I would refer to it before I would struggle trying to take it apart. 😊 So far everything looks very good on it and it runs on a prime shot. I have a Barker that is a twin to it other than it's yellow. Barker...

Trying to decide whether to do something with this or leave it as is.

Good afternoon. Been tinkering around in the shop trying to organize it which isn't going very well. 🙄 Just finished going through a Super 1050. When I picked it up it would just barely turn over when you pulled as hard as you could because the crank bearings were locking up. I put new rings...

I see you have a roll of Mono lawn mower labels. Power Products tag should have a hand stamped number in the center that will tell you what model saw it is. Good paint on a Mono brand is pretty rare. They normally left the wrap handle off and wrapped tape around the spark plug porcelain and...

Took some of my Missouri-built saws and made a dedicated wall. (Left to right) Top Row : Mono 1-16(77cc), Mono 60-20(77cc), Mono 35(77cc), Mono 47(77cc),Mono SL-245(70cc), Barker 105(69cc), Barker B Light Weight(32cc), Barker L-20(31cc), Mono 25(22cc) Middle Row: Barker Super C-40(77cc),Mono...

It's a Barker Super C-80 with a Power Products AH-81 engine. I figured that I could let one go since I've got 22 saws with that engine. Those 999f's are strong runners. I bet it would do well.

Me too. I just priced 12 runners to a guy. From 31cc to 131cc. We'll see how motivated he is. My new coffee cup that I had made.

Merry Christmas!

Merry Christmas!

Exterior trim is all original. It's been repainted. It was originally Mopar green. He claims that the paint used cost $5,000 per gallon.

It turned out to be a fairly decent car. Only had 47,000 mi on it.

Good morning! Going to head to Eureka Springs this afternoon to inspect a 67 Charger for Exotic Car Trader.