sawfun's latest activity
-
sawfun replied to the thread What Stihl trimmer should I get?.I had one of those fs550's and found a Stihl harness that fit me well. Mowing an acre of four foot grass on foot, was a breeze using the... -
I have yet to find a sling/harness I like but even with your Popeye arms I bet you would struggle a bit with my FS550 or FS350 after a...
-
Maruyama B300L is the Toyota Hilux of string trimmers. I've had Stihl, Husky, and Echo and Maruyama Is the best of them all.
-
sawfun reacted to lehman live edge slab's post in the thread What Stihl trimmer should I get? with
Like.
Run good oil and set the valves at around 100 hours and it will last a long time. People a can say what they will about the 4-mix but i... -
-
I bought a FS91R, 7 or 8 years ago and drilled out the main jet i think it was 15 thousandths stock and drilled it to 17 thousandths and...
-
For line once I discovered .105 Stihl X-Line I haven’t gone back. It’s aggressive but it cuts cleanly and even at low speed. At .105...
-
It still doesn't look like much, but is certainly runs and oils well. Mark
-
The piston and cylinder are in pretty good condition but the rings were questionable so I replaced them (PN 85245). The early 82 cc...
-
This one came in on Saturday. Guy said his uncle wanted it cleaned up and operational again. Made it to the bench yesterday. Rather...
-
7/16 was very common on many of the earlier direct drive saws. McCulloch supplied it on quite a few models and I have a couple of...
-
The one I have in the case looks like a mirror of the all red one with the blade on the right... Mark
-
This one should be OK. I don’t have the rings though.
-
Husqvarna 288XP. Beautiful saw. Top cover a little faded, but not bad, just being honest. Completely gone thru some years ago by Jacob...
-
I pulled this off the shelf the other day. These are not too easily located.