SawAddictedFarmer's latest activity
-
SModded 261 wears a 16" bar and 12" hardwood is my grab a different saw limit. 044 572 500i and a 592 with an 8pin all wear 20-24" 088...
-
SSawAddictedFarmer reacted to 59billy's post in the thread Not so pros 4 new and without politics or drama with
Like.
Good morning slackers. 55f headed to 56. -
SSawAddictedFarmer reacted to Stump Shot's post in the thread Not so pros 4 new and without politics or drama with Like.
Good morning 12F 🌥️
-
SSawAddictedFarmer reacted to ray benson's post in the thread Not so pros 4 new and without politics or drama with Like.
Good morning. 23°F/-5°C going up to 26°F/-3°C.
-
SSawAddictedFarmer reacted to beaglebriar's post in the thread Not so pros 4 new and without politics or drama with Like.
How’s the digit?
-
SSawAddictedFarmer reacted to ray benson's post in the thread Not so pros 4 new and without politics or drama with Like.
Very little pain, swelling going down. See the hand doc Thursday. Would like the index finger tendon fixed asap.
-
SSawAddictedFarmer replied to the thread Not so pros 4 new and without politics or drama.Good morning! 28 degrees here.
-
SSawAddictedFarmer reacted to jacktheripper's post in the thread So what did you buy today with Like.
I got my Cannon 50” 142dl .404 bar in today! Put it on the 394 to see how it looks and handles.
-
SSawAddictedFarmer reacted to jacktheripper's post in the thread Grinder Comparison Thread with Like.
I may just have to set up my second 511a for rakers…
-
SSawAddictedFarmer reacted to singinwoodwackr's post in the thread Grinder Comparison Thread with Like.
Point… But, I’m still gonna play with welding something :p
-
SSawAddictedFarmer reacted to singinwoodwackr's post in the thread Grinder Comparison Thread with Like.
Just learn how to finesse the thing. It just takes some practice. I’ll never go back to hand filing rakers except for doing the first 2...
-
SSawAddictedFarmer reacted to jacktheripper's post in the thread Grinder Comparison Thread with Like.
How do you guys like to go about setup for rakers on an Oregon grinder? I feel as though there is too much play in the grinder arm and...
-
SSawAddictedFarmer replied to the thread Ms362 base gasket delete and timing advance?.It sounds nasty!
-
SSawAddictedFarmer replied to the thread Ms362 base gasket delete and timing advance?.I didn't it .2" at the edge of the flywheel. I started it for just a second and it sounded like it was doing 4k and rough. Assuming it...
