president's latest activity
-
PCleaned up the new addition. Had the parts to throw some west coast trim on it. Still waiting on a carb kit.
-
PI did my 1st piston swap today. I did it on a Husqvarna 261with a 262xp meteor piston/caber ring. Modded the oem muffler after soaking...
-
PI like both my 572 and bigger heavier 592 the 500i being a bit lighter than either I enjoy it more the longer the day is, massaged by a...
-
PI've had multiple 385/390s with bad bearings lol.
-
P572s like to spin the PTO bearing, its an undersized bearing and there’s no case reinforcement, issue that arise especially with heavy...
-
PI have about ten saws including the 500i. 90% of the time I pick up the 572. Something about it just feels good.
-
Ppresident reacted to singinwoodwackr's post in the thread FOUND IT Husqvarna 266xp cylinder with
Like.
I have a couple nos topends but should have a good used cyl as well -
PHave you checked for flatness? I think I have had to sand some mating surfaces on 2 series intakes tracts.
-
PDid you change the piston ? sounds like a porting problem causing reversion at the inlet manifold How & where did you block off the...
-
PGot in there and put an oem length line in, couldn't make the filter fall to the right side when tipped. Shortened the line, still not...
-
PUsually when tipping a saw and it changes lean or rich means a leak and usually through the seals(Even a new seal doesn't perform as it...
-
PThis is a non-serviceable check valve and retainer. You will need a replacement pump body assembly.
-
Ppresident reacted to Wood Doctor's post in the thread HELP! Stihl MS 260 Pro oiling problems, burning up bar and chains with Like.
On occasion when this happens I remove the bar and chain, start the saw engine, and check to see if any bar oil is flowing it out the...
-
Ppresident reacted to Junk Meister's post in the thread HELP! Stihl MS 260 Pro oiling problems, burning up bar and chains with Like.
I have seen warped/tweaked side plates allow bar oil to take the course of least resistance and not to the bar itself. Does the 026/260...
-
Ppresident reacted to jacob j.'s post in the thread HELP! Stihl MS 260 Pro oiling problems, burning up bar and chains with Like.
Is your sprocket severely worn? Check the oil input holes on your bar and make sure they aren't plugged. As Custer posted above - make...