president's latest activity
-
PMy friend's dad had a Sansui set-up when I was in high school that would blow you right out of the house. I think he used the Bose...
-
PWaiting for parts. So today I decided to clean and lube pots and switches on this old girl. Hasn't been cleaned since new in 1978. For...
-
POne was just fine, the other got replaced with another used one. Both got sonic tanked in Berryman’s and checked for smoothness...
-
PThat’s going to turn out nice! Did the bearing get replaced or they good?
-
PStuck inside due to weather and waiting on parts for the 056. Decided to check out the top end on the old 066, which looks pretty good...
-
PDone. Mark
-
PI think that is standard practice with Lycoming aircraft engines. Thread and sealant.
-
PI used to use white cotton thread to help seal snowmachine engine crankcases. Put the sealer on and lay a single thread in the center...
-
PMore pics including parts list.
-
PIts just the 034,,, non super
-
Ppresident replied to the thread What's on your bench?.is it the super Bob?
-
Ppresident reacted to jacktheripper's post in the thread FOUND IT Wanted: 288xp Cylinder, Top cover, Clutch cover with
Like.
I can’t wait to give him this -
Ppresident reacted to jacktheripper's post in the thread FOUND IT Wanted: 288xp Cylinder, Top cover, Clutch cover with Like.
Haha, I was on the phone with him today. The saw that I have is actually from him lol. He’s fresh outta parts.
-
PYou know, I like Stihl quality even when compared to the other major brands. The 4-mix is quirky but it has a low rpm torque advantage...
-
PIn a diesel engine, the oil is clean only a short time after replacement 😎