president's latest activity
-
PStens would probably pass the standard tests for FD. However, passing is a minimal spec. Many oils surpass FD by a fair amount. Keep...
-
Ppresident reacted to jacob j.'s post in the thread STIHL The Official Stihl Chainsaws Thread with
Like.
Stihl 056 service bulletins I found on the interwebs a while back: -
P394 cylinder is NLA but the piston 503 46 02-02 is still available as of 07/23/2018
-
PI've had several and I think it was to keep impacted sawdust from building up around the decomp valve. My experiences with the...
-
PYou can wash the hi top filter very easily. I’ve done it before. Just spray with simple green let sit for a couple minutes then hose out...
-
PI will soon be building a pretty little 024 with an 026 top end on it. Will be for sale when I’m done.
-
PI have a thin ring I picked up that runs pretty good but some spare rings never hurt..
-
PI do, including a nos. But...the nos one needs rings 🤣 Might buy a pair since I got the piston for cheap :p
-
Ppresident replied to the thread VOTE NOW WHY DID YOU JOIN OPE.Needed more info so between both sites this one has less infighting
-
Ppresident reacted to Stem's post in the thread SELLING Stihl MS650 Cylinder and Piston new with Like.
064/early 066 is narrower bolt pattern
-
PAmazing engine - the 2UZ-FE 4.7L V8. My '02 Tundra just passed 200K miles; purrs like a kitten, smooth and quiet. Has never used a drop...
-
PI’ve seen several stripped case holes. 066, 372, 200t. Probably from someone using too much torque starting the bolt (like if the...
-
PThe cylinder bolts on the 562xp are to be torqued to 8-10nm as per Husqvarna service manual … the case threads proper will give...
-
PI thought they were there so they could use longer bolts, which would allow the bolts to stretch a little more and give more elasticity...
-
POn the carburetor, while yes it takes extra effort to remove by pushing the little tab on the bottom to release it. However, when it...