president's latest activity
-
PI was gone for an hour or so this morning, came back to find these outside the back door. Like our old friend Sgt Schultz...I know...
-
PMOAR POWER!!!! I bet it sounded real good while it was dying!! 🤣
-
POkay, now theres a demand for videos of you doing machine work in high heel. I wish you, and your youtube channel, the greatest success.
-
PA customer thought his 461 would run better if the H screw was turned in a couple of turns. As he found out, that was just a temporary...
-
PI've ordered stuff out of their eBay store and their website - but you have to know what you're looking for and be pretty sure about the...
-
PIf the saw will tune for it and it’s not building carbon, there are no drawbacks. In fact if he knew much about strato technology, he’d...
-
PFor our 358cid restricted race motors We seen 7-11% gains on the dyno running E85. We normally run 110-112VP... our motors range from...
-
PAccording to a couple guys in the know, even octane booster needs added in crazy quantities to actually raise octane for a vehicle. Like...
-
Pif adding oil to the gas lowers the octane by what some say is two points at 50:1 and you start with 87 that means that if you mix it to...
-
PMy 2188 is LOWD
-
PI mentioned before that I had a 2188 run quieter on 93. 87 & 89 wouldn't do it. Probably gained a smidge of torque. It's the only saw...
-
PI believe it’s detonation that doesn’t have time to be possible, but I’m not sure. I have heard the same thing though. One of them is...
-
P87 is fine if it’s fresh. Octane depletes as it gets old, so after awhile 87 is no longer 87. More octane is just more resistant to...
-
PNothing like a clutch burnout on the shop floor
-
PExploding a clutch in the shop is a rite of passage. That moment when you realize you still have both eye's is priceless. Also you...
