president's latest activity
-
PDon't forget to put the clutch cover back on when testing the saw, don't want a clutch to come loose and spin off of the saw at great...
-
PI also went through my new barn find white top 61 practica. I removed the muffler baffle, replaced the coil, rebuilt the carb, and...
-
PI'm gonna drop a hot one here! The MS441C or regular carburetor. I think a saw of that build complexity SHOULD have left the factory...
-
PSome weeks back a fellow traded me an anvil in exchange for putting his 285CD back together. He said it just locked up when he was...
-
P026 and 066
-
Ppresident reacted to huskihl's post in the thread How many degrees timing advance MS 400? with
Like.
Yeah if you ran out of screw adjustment. No reason to do it unless the screws didn’t allow enough extra -
PDiamond probably has them but I haven’t checked their site in a while. They are not as good, imo, but many here like them.
-
PSo I have to order one from Lithuania? There is no dealer in the US?
-
PBaltic has them…I have a couple. Shipping from Lithuania is still costly so take that into consideration. I have a new one in route so...
-
PAnyone looking for handle inserts?
-
PJust to wake this thread up... New to me 88, needed new ring otherwise pretty good nick.
-
PI'd be interested to see the carb linkage set up. The 181 used a metal rod link connection to the carb. The 288 used a pad contact...
-
PI think I see the bar pads present, the clutch however appears to be out too far as in something is holding it back from going in all...
-
PEarly models had both an inside and outside steel bar pad, later models had just the inner one.
-
PA well built 395 isn't going to be ousted by a 592 as pointed out by Shaun below. I do think there is a chance that a well built ms661...