president's latest activity
-
PA properly ported 026 top end on an 024 Super chassis makes a very fine runner - It's unlikely you're going to make much more power with...
-
Ppresident reacted to stihl #1's post in the thread Chain Service Tools and Sharpening Station with
Like.
I have used the 15 degree setting for the last 25 years and never had a complaint, even had more than one occasion where I was told the... -
Ppresident reacted to stihl #1's post in the thread Chain Service Tools and Sharpening Station with Like.
cus_delexe, I have 2 BP1 saws, one is complete with the bar and the sharpen on the saw chain and runs, the other is rough. I am still in...
-
Ppresident reacted to Mastermind's post in the thread Simplified---Adding A High Speed Circuit To A WG Carb with Like.
Ok. Just the basics. I start with a 4mm x 25mm allen head screw to make my needle from. The paper in the picture has the dimensions...
-
PIt will center itself, if you let it, by doing the flywheel side first and placing the bearing fully in the pocket. This will...
-
Ppresident reacted to stihl #1's post in the thread Chain Service Tools and Sharpening Station with
Wow.
This is the sharpening setup, on casters. This side has a grinder setup for 0.050 gauge chains and a hand filing jig. This side has a... -
PFor those people watching the video... just to clarify... Position the bearings in the crankcase properly first. Once they are in the...