president's latest activity
-
PThat sucks to hear. I was getting my 261 ready today to take firewood cutting tomorrow and it was giving me fits, didn't want to idle...
-
PFor that matter if you have a collection of old carbs you can rob a ball from a Walbro,Tilley or Zama to get by with . I've managed to...
-
PHave one off a 380 and a 2100. Venturi measures the same and they're both marked HS136C.
-
PThat’s a good thinking. I believe the the reed engines start sucking mixture the moment the piston start moving up. Way more time for...
-
PYou wouldn't notice any gains until you have a pretty decently ported cylinder and such.
-
PThat crack would cause problems, no doubt. Have you tried blocking off the little H and L fuel inlet holes on the metering side...
-
PVenturi is large enough, throttle and choke are the same?
-
PHave you taken it apart to see if the spring is sheared or not? I have had a few saws that I got where they would not recoil and it was...
-
P+2 I bet this one would run a blender attachment extra nice. Frozen margarita season is coming right up fellas.
-
PHe's got an electric knife and Kathy Bates lives in his hometown.
-
PI’d have an adjustable H jet installed rather than being limited to a fixed hole
-
PAwesome, good info I appreciate it! I think I have a 1309 left over from a early 046 I’ll use as well as a 1300. Just had to pickup...
-
PThe 440 and 044 (10/12) came with the 1300 ”dummy” coils. The 046/460 came with the coil that had start retard on it. Not really...
-
PYep, I should have press/vac tested to confirm. Someone was itching to dive into it. But I think you correct, bad fuel/mix maybe some...
-
PHave you tried using different Fuel? If your gas has any ethanol in it, the ethanol contains oxygen and that will lean your fuel mixture...
