Recent content by Partner

https://www.acresinternet.com/cscc.nsf/ed1d619968136da688256af40002b8f7/d907694e259c5be188256b5e001404c2?OpenDocument

It could be 600 check Mike's website

A bit of Dremel and I turned the guides to the other side because it was already very worn / Chinese maple

I am adding an additional spring to the Chinese clone T25

I'm about 500 km from the sea, I'd love to turn into amber 😎😉

Instead of an address, look for 6 states / there is one and we are Stan Borys 😉👍

You remove the oil pump drive ring together with the crankshaft bearing 😎👍

They are easier than 026 😎👍

Thousands of dollars are hanging on this stand, i.e. more expensive than Stihl and Husky 🤠😎👍

I'm testing the T45X on a Husqvarna 153R 1.5KW, 53cc the Maruyama engine runs like hell, a 3 or 3.5mm line, it seems to be doing better than the Kawasaki 2KW Red 🔺 over 3mm and orange 🔸 3mm

It seems to run better than the Kawasaki 2KW, it has a strato engine and higher head speeds There, a 3mm line will clog the engine, a better one would be 2.7mm

My bench used to be a 200L oil barrel 😎👍 Or the catering table is quite high like mine 🤠 I still have them

It must be like this because the liquid is outside in this case. This is the case with a better water pump or outboard motor

I added 2 razor blades to stop it from falling out and I wonder if it's the original simmering with a rubber ring on the outside. Now it works properly 😎👍 This engine has a muzzle anyway 😉 1.5KW 53cc

Are Japanese coils defective? 😉 I just replaced it at Kawasaki now Miruyama and now I found out that it's time to order sealants 🤠👍 And it doesn't go out 🤠👍 it just slowly increases its speed. It's the second time in my life I'm seeing this 😎