Partner's latest activity
-
PI think I’m going to be doing a 266 top end swap on my new-to-me white top 61.
-
PI just use this undiluted on a cue tip. The aluminum transfer foams up, the plating doesn’t.
-
PPartner replied to the thread So what did you buy today.Similarly, when cutting steel, one disc wears out slower and another one wears out faster 😉👍
-
PPartner replied to the thread So what did you buy today.I don't know about your current 😉 our largest 5" is 9.5A / It's not about power, but about operating time. A larger engine is less...
-
PIts a 13 amp 5inch. So it's on the "larger" side of the small grinders! But it's definitely not lacking in terms of power. This thing...
-
PPartner replied to the thread Oil questions....A few more posts and it will be the best one 😉👍
-
PPartner replied to the thread So what did you buy today.I like how a small angle grinder has a powerful handle 😉👍
-
PA new 372 bottom end,an asylum 13 8-80 cigar (crocodile Dundee cigar edition lol) and a 3m Angle grinder!!
-
PWrong flag, its the 333, 336 339xp clutch cover.
-
PIt's for a 335XPT. Picture is not my saw, just one I found online.
-
PThey could never make those these days. Someone would be protesting.
-
PPartner replied to the thread What's on your bench?.The cover has one screw, so definitely nothing that is on the list
-
PA customer thought his 461 would run better if the H screw was turned in a couple of turns. As he found out, that was just a temporary...
-
PThose little shiny hanging down things? They are my circlip installers for piston pins. 9-13mm I need an 8 to have a complete set (I think).
