Partner's latest activity
-
PI also went through my new barn find white top 61 practica. I removed the muffler baffle, replaced the coil, rebuilt the carb, and...
-
PToday I got the crank case together with new bearings. I’ve always used a sealant like dirko on the case gasket, but this will be an...
-
PNice size Ash killed by the EAB. Hooked up the tractor when dad was out feeding cows and got it pulled out to flatter ground for cutting.
-
PEarth drilling
-
PJred 630V. This was a raffle saw I won a couple years back (not a runner). I got it running and found out the clutch drum was shot and...
-
PPartner replied to the thread What's on your bench?.And what's hanging under the counter on the right side 😎?
-
PSome weeks back a fellow traded me an anvil in exchange for putting his 285CD back together. He said it just locked up when he was...
-
PI try to leave the shop and museum open even when I am gone for a few hours in case someone stops by and wants to look around or leave...
-
P026 and 066
-
PPiston and cylinder were fine. Crank was fine. I got lucky. Cases cleaned up, old bearings removed. Ready for reassembly tomorrow with...
-
PWell it has become very obvious to me that I somehow sabotaged my own saw. As soon as I started tearing it down, I removed the air...
-
PI agree I live my life doing that These are made of metal and I salvaged them to build a shop out of them. Footings are done next...
-
PPartner replied to the thread The Metalworking Thread.Someone will probably ask what this metal is for 😉👍
-
PI want to use my 266xp again, so it’s time to tear this thing down and do the bearings
