Partner's latest activity
-
PTook the 32 off the 460, where it’s lived for a while. Then I cleaned the saw up and put on the 28” Cannon Duralite… It looks so good I...
-
PI'm famous for greasing non greasable/sealed bearings. Generally a bearing only goes bad when it runs out of lube. Good job!
-
PI like it when somebody’s not afraid to try to fix something. It’s already broken, what does it hurt to try (unless it’s a life safety...
-
PPartner replied to the thread So what did you buy today.I drilled a hole in the bearing housing near the commutator, added grease and sealed the hole with hot glue 🤠👍 I didn't know it was...
-
-
PPartner replied to the thread So what did you buy today.It's bad 😉 it can't be disassembled, maybe the transmission and electrics behind the engine will remain along with the speed controller / $5
-
-
PSlab was poured on Monday. Mark
-
PRebar, contractor took care of it. I probably didn't have enough old chain around to do the job anyway. Mark
-
PSlab has been done for almost 2 weeks, contractor stopped by yesterday to let me know he plans on starting the framing next week...
-
PI made a husky clutch removal tool. I have considered buying one, but I have a TIG welder and a bunch of old sockets and tooling I could...
-
PWednesday a guy pulled in to where I’m with a truck full of saws and other two cycle junk with this buried in the load. I told him I’d...
-
PPartner replied to the thread The Husky 42/42 special/242/246 thread.I was amazed that it worked at all after such changes / the crankshaft was corroded on every possible bearing 4 pcs
-
PThis $220, filthy faded screamer has a muffler that is so rusted, you can't remove the bolts. Stripped out trying. Gobs of compression...
-
PPartner replied to the thread The Husky 42/42 special/242/246 thread.I didn't measure this new piston with windows, which is a pity
-
PAftermarket 242 piston is the only one available that I know of. Don't buy the Meteor as the crown is 0.8mm too low on it.
