PA Dan's latest activity
-
1129 141 2200 is part number -
Yeah it’s an OEM boot ,Correct part number ,Is it possible the plastic holder is worn and not holding it tight enough
-
I've never seen a new boot leak at the cylinder. is it a oem boot? correct boot? part number?
-
PA Dan reacted to cuinrearview's post in the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl with
Like.
I have one of these on my ported red 346. Feels like the perfect fit and balance. With an eight pin rim it's a hell of a firewood... -
PA Dan reacted to Duane(Pa)'s post in the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl with Like.
Make an offer and BUMP
-
PA Dan reacted to Duane(Pa)'s post in the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl with Like.
No. They are SMH unmolested. Pretty sure I went 3/16 on oil hole.
-
PA Dan reacted to cuinrearview's post in the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl with Like.
Have these been milled/modded to Stihl specs or what?
-
PA Dan reacted to Duane(Pa)'s post in the thread SELLING Sugi Hara Lightweight Bar KO95 3/8"x 18" x .050 x 68dl with Like.
Make an offer. I'm going .325 on everything under 20"
-
I have never been able to tell any difference from behind the saw. My smoothest cutting chains are the ones with the most consistent...
-
I've been using my MS661c and a Granberg 36" mill for over 10 years now. I've milled hundreds of boards with it, and have saved...
-
PA Dan reacted to SOS Ridgerider's post in the thread Tecomec chain spinner and breaker...are they any good? with Like.
I just bought the Tecomec set myself. Been using a cheap HF unit up until now, but the Tecomec set is much nicer. Only used it once so...
-
PA Dan reacted to angelo c's post in the thread Tecomec chain spinner and breaker...are they any good? with Like.
...someone say they were looking for an Italian ?....
-
Got it cleaned up nice. Needs points cleaned.
-
Yeah, ya never know where a roving truck load of Mini-Mac's may wind up being delivered, ask me how I know...
-
PA Dan reacted to Woodslasher's post in the thread The giveaway thread 20/21/22/23/24/25/26 with Like.
Then it's yours.