PA Dan's latest activity
-
I took a fall at work last Thursday night that resulted in busting my head open and a trip to the hospital where an MRI was done and... -
Excellent, cause I got bupkis. I'd take a well-used one over an AM case any day.
-
The closed port uses the same intake as a 372 I believe.
-
Never saw that last night.I was just looking at pistons since my cylinder is perfect. That’s a good deal but only thing is my 365 has...
-
Just swung over to HL Supply and had a gander... Jeez, if you are considering giving Tecomec a try, kinda hard not to pass this whole...
-
Same here... We talked about the Tecomec 242 cyl kits pretty extensively in my 242 thread. I'd like to get one to put up on a shelf for...
-
I’d try a lower exhaust and much higher transfers
-
PA Dan replied to the thread Run it, cut it, or trash it?.I bought a Tecomec 365 cylinder kit for cheaper than it would cost to have the cylinder machined. They run great and there would be no...
-
You have the sister saw to mine. You know what I'm talkn bout :afro: Steven
-
I just took a screen shot of your message and sent it John's way. He gets busy occasionallay
-
John, Im ready to pay for saw. I bought a 4300 from you in 2019 with muff modded; What would it take you to gut the muff? Young in...
-
She is hung up on getting a smurf one. But may have to move to a 5105 if can't locate a 4300.
-
My 4300 is German made.
-
I would take the Dolmar made in Germany over the China? made Makita
-
It’s an easy start, she would have no problems.
