Recent content by Outback1

You have parts for the Dolmar/Makita 6421? I’m looking for the washer that goes behind the clutch on the 6421 and I think it’s the same part as for a 7900/7910. Part #181-224-090 it’s listed as a shim. Thank you

Is this gone?

Ok let me know as I have the funds.

Is this project saw still available? You will ship to California? Is the ignition there as I did see it in the picture?

Will you let us know all the steps it takes to convert the 198/199 to an 87? I have a 262 that I’d like to do this too as well.

I have a MS461 built by Adam Baker of Bakerized Chainsaws and it rips. Have never heard of the other guy?

I’m looking for an air filter and an air filter cover for a Jonesred 2051 Turbo. If you know of any for sale please contact me.

I’m into Oak, Doug Fur, sugar pine etc. I think it’s a small pin mount for a bar correct?

Thank you for your information. I’m just trying to figure out the Husqvarna saw it shares parts with in case I need some replacements?

Thank you for the information. I was thinking a 20” bar as well. I’m trying to figure out which saw in the Husqvarna line is a match so I can cross reference parts in needed?

I have just acquired a Jonesred 2051 Turbo saw and was wondering what size bar should be used and what is your thoughts on the saw?

I’m inquiring about this saw for a friend since I don’t know much about Remington saws? He has a 754 Super with a 25” bar and chain. It starts and runs but haven’t seen it in wood. What is a saw like this worth? Of course it looks old as the paint has faded but it’s all there with no issues...

I need a service manual for a 026 & a MS440 magnum please. Thank you.

Still have the #2 cylinder? Could I get a picture of inside the jug please?

Who likes them Makita/Dolmar DCS 9010?