oddsaws's latest activity
-
She was watching closely... ...as I was doing lunch. -
oddsaws replied to the thread The Swap Meet Thread.Anyone into Husky 357s…I have a new OEM 46mm piston for the 357s with the narrower crank small end. Swap for a 357/359 carb? 13mm...
-
-
55 little steak bites. Largest check I’ve written out in a while.
-
oddsaws replied to the thread Trees you've cut.Sorry to go off-topic on this one, but have you seen the film In The Land of Saints and Sinners? Pretty sure Liam Neesons character is...
-
i sent you a pm
-
oddsaws replied to the thread HELP! Husqvarna 357/359 carburetor.Looking for a few more carbs if anyone has anything - W hda199 or Z el42. Also need air filter elbow(s) for 357/359. Thanks!
-
No longer available
-
oddsaws replied to the thread What's on your bench?.What’s not on the bench right now is the question..Stihl?
-
-
H&L has the Warhawk 346xp kits again. I don't know what their quality is like these days, but they were getting good reviews 5 to 10...
-
I have had one on and off relationship with 346, have had 6 at the top, and also been down to 0, right now I have three, two in mint...
-
Probably 50% of my stuff falls under the shouldn't have bought list, including my first marriage license.
-
We had a minor kitchen fire last night, fortunately we were able to get it put out. It did remind me to check all our fire...
-
I've had an 038 Super for a while, one of my first non- yellow saw purchases . I replaced alot of rubber parts on it and it followed me...
-
Disston KB-7 looks like. It looks like it has the muffler, which is a very rare piece. I dunno about value. @Bill G might.
-
I have the oem 460 covers on 350s, 346s, 357s, & 359s, it is so much better. I have not tried aftermarket covers.
