MustangMike's latest activity
-
MustangMike reacted to Mastermind's post in the thread Post up your ported cylinder Artwork with
Like.
The first cylinder I ever "ported" was done with a broken piece of round file in a drill. -
MustangMike reacted to SOS Ridgerider's post in the thread Dolmar 64xx/73xx/79xx series, smurfs and solo 665/675/681 thread with Like.
I use mechanical a lot as well, but this one is brand new, so I had to show it off. Lol
-
Thanks, will try that next time.
-
MustangMike replied to the thread Dolmar 64xx/73xx/79xx series, smurfs and solo 665/675/681 thread.I have always used my mechanical Craftsman calipers ... never needs a battery!
-
MustangMike reacted to SOS Ridgerider's post in the thread Dolmar 64xx/73xx/79xx series, smurfs and solo 665/675/681 thread with Like.
I wonder where they went…?
-
MustangMike reacted to Mastermind's post in the thread Post up your ported cylinder Artwork with Like.
I don't use anything on the diamond burrs.
-
MustangMike replied to the thread Post up your ported cylinder Artwork.I know that OEM plating is generally harder than AM plating, but I would practice on an AM cylinder before ruining an OEM cylinder...
-
MustangMike reacted to Mastermind's post in the thread Post up your ported cylinder Artwork with Like.
I use these. https://ebay.us/m/5W2RYt Takes practice. Start on the left side. Wide open. Straight up to the stopping point.
-
Whats best method for removing the bulk of material on top transfers? I've experimented with a few cutters on my right angle handpiece...
-
MustangMike replied to the thread Post up your ported cylinder Artwork.My brother and I were unable to start his Asian MS660 on Friday, so today I took a look at it. Checked the air filter and plug, both...
-
-
I do have a set of the diamond balls of various sizes but I'll order some of the various shaped ones as well. I'll cut the stems on a...
-
MustangMike reacted to Mastermind's post in the thread Post up your ported cylinder Artwork with Like.
Looking good. I don't use a single or double cut burr to tidy up the corners of the upper transfer ports. I use a 180 grit diamond burr...
-
I got some time this evening to rework the ports. Still not real artwork, but tried to follow the advice given. Ended up 98 / 118 / 81...
-
MustangMike replied to the thread Post up your ported cylinder Artwork.Al, I remember you did some incredible work on my Hybrid, and I used it yesterday to drop this large Sugar Maple stem. The 28" bar was...
-
-
It’s unfortunate that Stihl took a step backwards with the 54mm “upgrade” from the 52mm 064 cylinder. I still don’t understand why...
