MustangMike's latest activity
-
Is it worth advancing the timing on a non ported saw? IE: 350/346xp with we base gasket delete and muffler mod? -
Husqvarna 51. Ditched the tiny factory deflector, opened the hole to 1.300" x .700" and used one of Joe's medium deflectors with a...
-
A few winters ago my dad and I decided we had to fire up his Bandsaw Mill after it had sat for 6 or 8 months. We got it hooked to a...
-
I found a mouse skeleton in my 4200 poulan muffler when I got the saw.
-
We send a rubber bung with the saw.....to cork it with when not in use.
-
MustangMike replied to the thread Show off your muffler mods.Randy, is that outlet the correct size for Bluebird nesting?
-
Too purdy to get dirty…
-
Go Bubba ,
-
-
Good worker. Torquey and should break in well.
-
Pickings are scarce. Had to noodle.
-
Still playing with 50cc stuffs...
-
MustangMike replied to the thread Question about Crank Stuffers Case Volume and Primary Compression.Al, I'm not saying it is anything like Deets saw, but after my busy tax season I've got to make some time so you can get some trigger...
-
MustangMike reacted to Ketchup's post in the thread Question about Crank Stuffers Case Volume and Primary Compression with
Like.
That would make sense in the same cylinder, but the XT bore is taller. The piston windows offset it some, but I’m relatively sure now... -
MustangMike reacted to drf256's post in the thread Question about Crank Stuffers Case Volume and Primary Compression with Like.
That saw was and is impressive. Pretty sure it’s back in Deet’s hands. A total worksaw that he made a V stack for. It’s was impressive...
