Maintenance Chief's latest activity
-
I would personally wait. If it isn't leaking I say leave it alone. In my opinion sometime messing with them creates a leak when... -
Do the other one now, or do the other one later. You have it figured out now and can probably do it in an hour this time. And yes...
-
I had a brake job done on my Toyota FJ by a tire shop. I mentioned the leaky axle seal, and afterwards they told me they don't do that...
-
An update kit came out several years into production because they were chewing up bearings. It uses an 044 clutch drum and a larger bearing
-
Maintenance Chief replied to the thread HELP! Ms441c Reset Trouble.Depending on the year they came out with a warranty coil and carb. Check your linkage from the carb to the strato butterfly, they can...
-
Maintenance Chief reacted to ManiacalMark's post in the thread HELP! Ms441c Reset Trouble with
Like.
I believe what I did is the correct reset procedure. But, towards the end I never heard it clean up and run smooth, and now it idles... -
Maintenance Chief reacted to aarongd's post in the thread HELP! Scammer Alert!!!!!!!!!!!! @Cupholder with Like.
i generally do as well but still got scammed. I needed ther part so bad as well but i assure you it will never happen again. Screw me...
-
Maintenance Chief replied to the thread Trash Picked A Stihl 270..With trash picked saws, and I've got my share! I always replace the crank seals and impulse line.
-
OK, here's where we are wiith this project. Recoil starter works OK, engine starts. Will only run with the throttle fully engaged. It...
-
Maintenance Chief reacted to huskihl's post in the thread HELP! Chinese clone chainsaws - worth the hassle ? with Like.
Like others have said, you need to be able to tinker to keep them working properly. Most that have bought them say that by the time they...
-
-
-
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
I'm yellow with envy Squareground, second generation 7-10 with a full wrap, very nice. Mark
-
I also love my TM462, I have an the Egan setup on my ported 261 and will most like get one for me 462. I am not really a fan of cutting...
