Maintenance Chief's latest activity
-
Fixed it right this time even though the boss looks at me like it took too long. -
Spent two hours putting a master cylinder in my wife’s car just to realize there’s an o ring on the back of the master cylinder I didn’t...
-
He has them...you should see the attic 🤣
-
I have about 75% of the shelves painted and up in the display area. Those on the far wall have not been painted yet, that will be a...
-
Finally gonna start a 2100 build. I have 2 nearly complete saws to play with so will be grabbing parts from whichever box is needed. I...
-
MS462 V1 See if you can spot what went wrong. I spun a hone in the cylinder a little and it actually would clean up above the exhaust...
-
Maintenance Chief replied to the thread Saw video thread.Funny but I recently dropped a saw while cleaning it and whacked the back of my hand with the chain, consequently wearing a bandage for...
-
-
Tuning screws hard to find. I need to pull limiter caps again and make sure they are lined up.
-
Finished this 461. Had to drill carb jet from .022 to .026.
-
Maintenance Chief reacted to jacktheripper's post in the thread STIHL The Official Stihl Chainsaws Thread with
Like.
041 Super -
Maintenance Chief reacted to lehman live edge slab's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
Which depending on how much use ect and if you feel like making or dealing with adapters is may be better going this route. Or just fine...
-
Sold
-
Maintenance Chief reacted to upstateamish's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with Like.
Dyno Results are in! The third Prototype saw came in 20th out of the 41 saws. Some great info and interesting to see where it baselined...
-
