Maintenance Chief's latest activity
-
I think most builders on here modify the original muffler. -
Maintenance Chief replied to the thread Fixing hole in tank.Jbweld is what I've used on a dozen mag tanks, the sealer is a little $$ but the can I bought is probably gonna last me my lifetime...
-
-
That hole is right next to a seam which is probably glued so welding is probably not an option as you'll burn the glue out.
-
I would favor JB Weld, grind or sand (coarse grit) around the hole, JB all around, press in a piece of screen wire and finish with JB...
-
My first thought was to put the screw back in. Lol
-
All of them, I wouldn't have listed them otherwise. @srcarr52 welded countless chainsaws cases and cylinders both saving them from the...
-
@srcarr52 @tree monkey @dall just a few off the top of my head around here besides all the welding shops out there...
-
I've had great sucsses with JBWELD.
-
pop rivet and redkote?
-
I have fixed a couple of holes in tanks using JB Weld applied from the outside only. Just make sure it's roughed up a little, is clean...
-
I would thread it with an 1/8 inch pipe tap then screw a brass plug in with loctite on it until it tightens up then grind the outside flat.
-
Shining a flashlight into the tank, there is luckily no corrosion inside of the tank. There is just a very minimal amount on the bottom...
-
With the possible white death corrosion looking at other areas in the picture, you may have to JB weld and use a tank liner like POR-15...
-
You said “Patient” 🤣 Good to see this Doc!
-
Maintenance Chief reacted to TheDarkLordChinChin's post in the thread Trees Other People Have cut with
Haha.
Just seen this on Facebook.
