Maintenance Chief's latest activity
-
That’s going to turn out nice! Did the bearing get replaced or they good? -
Stuck inside due to weather and waiting on parts for the 056. Decided to check out the top end on the old 066, which looks pretty good...
-
-
She digs holes narrow & deep, then gets angry at the hole for getting stuck with her chest. She did get the mouse though! 🥰
-
I’ve had better success with The Right Stuff than Dirko.
-
Maintenance Chief reacted to farminkarman's post in the thread Husqvarna 350 build thread with
Like.
The only sealant I’ve had fail was Hylomar blue. I’ve never had Dirko fail, and I know others have had the same good results with... -
Did You stuff the paperwork into the boiler?
-
I only smoked my pants from the 9" grinder / I don't count the landing from an overturned agricultural trailer because it was on your...
-
Maintenance Chief reacted to farminkarman's post in the thread Husqvarna 350 build thread with Like.
If the gasket were that important I could see it, but it isn’t. I only use base gaskets on some builds where the cylinder base can...
-
It's amazing the sealant works at all considering how thin it is, but it does.
-
Maintenance Chief replied to the thread So what did you do today?.I was drilling out a waterpump bolt on a Chevy in my 20s and had hair down to my belt , the drill grabbed my hair so quick I thought...
-
I met a guy that got himself wrapped up and yanked on so hard by a large angle grinder that it jacked his back up, put him on permanent...
-
Angle grinder,,, you smell the damage before you feel it,,,,trust me,,
-
Yeh, those angle grinders will give you a heavy case of 3rd degree rash real quick. My Dad had a wire wheel throw a wire up his nose...
-
Lathe accidents? Been thirty odd years. A guy had a conveyor roller shaft set up in a lathe. The shaft was too big to fit inside the...
