Maintenance Chief's latest activity
-
Maintenance Chief reacted to farminkarman's post in the thread Any Chinese chainsaw and chinese parts discussion with
Like.
On most of the clone 372's I have messed with, they use a different oil tank vent than OEM uses....I suspect that is the culprit, but... -
Maintenance Chief reacted to farminkarman's post in the thread Any Chinese chainsaw and chinese parts discussion with Like.
After helping a friend put up approx 8 cords of wood two weekends ago, I decided he needed a better saw than his tired ms290. I took...
-
Maintenance Chief reacted to SawAddictedFarmer's post in the thread So what did you do today? with Like.
I got the tractor stuck setting out a bale for the cows. I managed to rock it out in forth gear and filled in the ruts, everything was...
-
That's outright tragic!
-
Maintenance Chief reacted to Max the Mac Man's post in the thread MCCULLOCH The official McCulloch thread with Like.
My tenure in NOS parts has proven one thing (among others). That when it comes to McCulloch yellow there is no "right color". The shade...
-
Well, I pulled the trigger on one of these with my recent order. When it gets here in a month or two, I'll provide a write up of my...
-
Maintenance Chief reacted to SawAddictedFarmer's post in the thread So what did you do today? with Like.
I just finished 37 push ups in 4 sets in under 3 minutes. I injured both shoulders over the summer so I'm getting to the point of not...
-
I wouldn't pinch the groove closed too tightly and then re-grind the because you'll weaken the rails at the top. We used to close the...
-
Just got done putting this 143 together and could use the money for some other house projects I have coming up. Pretty nice saw started...
-
Maintenance Chief reacted to Bill G's post in the thread Makita exits gas equipment manufacturing with Like.
So were Homelite, McCulloch, Poulan, Jonsered, Pioneer, and countless others. It is all about the bottom line and the bottom line is...
-
Maintenance Chief reacted to lehman live edge slab's post in the thread STIHL The Official Stihl Chainsaws Thread with Like.
He could have a weak spring below the metering lever also not holding enough seat pressure because pop off is too low. All depends if it...
-
Most members couldn't fathom the miles my DAD could get out of a foot of Bailing Wire. The same goes for bars. If he did something...
-
I assume you have checked the Tube ... SCAR did one 13 yrs ago the comments are certainly worth reading. I searched "Hard facing...
-
I put a straight edge against the side of the bar and a cutter, the cutter tipped sideways enough that it did not hold the straight edge...
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Is that a laser Max? Are you getting into the gasket making business too? Mark