Maintenance Chief's latest activity
-
Gave a coworkers Echo 3450 a tune up. -new bulb -new lines -cleaned air filter -new plug -low jet adjustment -fresh mix If you wipe... -
Good show Hilux seems very Aussie
-
There was one spruce overhanging a power line. It must have uprooted in a storm and the ESB (Irelands state power company) cut it back...
-
We got all the trees done and dusted in two days then spent another day putting up new fences and cleaning the place up. This ash was...
-
We did a big site clearance job this week. 28 trees removed, mostly big spruce and a handful of big ash. We brought in some...
-
Maintenance Chief reacted to jacktheripper's post in the thread SELLING Nice Flat Top 066 with
Like.
I couldn’t… it was my first saw. It started the whole journey -
I like those saws, sir. I did see the 923 listed for sale here. The seller was good enough to run an inspection cam down into the...
-
Follow-up on the pool cleaner repair: Replaced the servo motor and seal. Couldn’t get the motor to get past the self-test while on the...
-
Or, an 020 :p
-
I found a 923 and a 955 but all I did was get them off the shelf
-
Well I’m back to logging for the season. I’ve been running my 20” bar a lot lately, and the Duke’s chains I have are for my 25” bar...
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
Rather than tear the engine completely down again, I swapped the flywheel and starter shaft from an 850 that allowed the cover to fit...
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with Like.
I put a note in the small parts bin with the dowel pins so hopefully I remember to check these in the future. I also noticed there are...
-
Maintenance Chief reacted to heimannm's post in the thread MCCULLOCH The official McCulloch thread with
Sad.
I was putting a PM800 together and learned a valuable lesson about the dowel pin (110851) used to locate the bearing insert on the PTO... -
Maintenance Chief reacted to lehman live edge slab's post in the thread MCCULLOCH The official McCulloch thread with Like.
I bought a tire tube to cut pieces out of for that on other saws. Didn’t realize but most tubes are butyl rubber now.