Loggernate's latest activity
-
The inlet screen should be thoroughly checked as a fuel blocking light film can be present that looks near invisible until it's removed... -
Make sure the purge bubble is hooked up correctly. The short side of the purge bubble goes to the S shaped hose. I’d replace the fuel...
-
Thank God someone else said it.
-
It sounds like Gordy at West Coast Saws needs to design a set of three-points for this...
-
The spikes are my least favorite thing about the saw. The positioning and the spike itself are garbage. Looking forward to an upgrade.
-
I wonder when (or if) they started to incorporate the updated boot into production...... yeah, that's a lot of time!!! sorry. I'll...
-
2022 Saws have this much time on them... You could have saved me the effort had you done so sooner. Lol
-
That's it, Humpty and Dumpty are back together again...
-
The second saw did not have an AV issue and still cracked the boot, so that is NOT the problem causing the cracking.
-
Drilled a hole slightly larger than the fine wire to use for a safety on the right AV.
-
Plunked the carbatrator back in with a light push.
-
I used a star ball driver from Echo on the attachment screws. Which is about as much as can be said for Echoes and 90cc class saws in...
-
Well, as far as whether or not it will come apart, everyone was right and everyone was wrong. It will come half way apart as you can see...
-
Good explanation, I’ve never done much with 200 series at all, my 300 series experience was with the red versions and they got...
-
I purchased the last two an outfit in New Hamshire had, if it wasn't for that, these two saws would be sitting here until they weren't...
