Ketchup's latest activity
-
Ketchup replied to the thread The Official Craigslist & eBay Thread.https://denver.craigslist.org/bfs/d/denver-concrete-rock-asphalt-chain-saw/7882546437.html Looks a lot like a Dolmar 9010… -
Ketchup replied to the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube".It’s lighter and smaller. Just the smaller tanks means a lot less weight. You do have to fill it more often…
-
Ketchup reacted to jacktheripper's post in the thread Hybrid clonesaw 365 with a 390 topend - aka the "86'r from youtube" with
Like.
Any more updates? -
My understanding is the xt cylinder flange is longer than the oe flange and will bottom out in the oe case. If it doesn't bolt down all...
-
Thousands of dollars are hanging on this stand, i.e. more expensive than Stihl and Husky 🤠😎👍
-
Last night I made a surround that I can use around my chain sharpener and vise. Made out of a sheet of hvac duct. This will hopefully...
-
Ketchup replied to the thread OE vs xtorq question.If it fits, it fits. But bolt the cylinder down and spin it. The piston doesn’t travel the same without the jug. Of course, you need a...
-
Ketchup replied to the thread 881 vs 661.661 with 36” or ported with a 42”. You won’t use the 881 nearly as much. Edit: Why not both?
-
Ketchup reacted to lehman live edge slab's post in the thread Post up your ported cylinder Artwork with Like.
Ground the holes bigger 😂
-
Husqvarna 357xp. Hopefully it runs
-
Ketchup replied to the thread HELP! Understanding piston design.Cheaper to modify existing pistons than cast jugs with higher transfers?
-
-
-
D
-
Ketchup replied to the thread Saw displacement classes.There’s no real consensus. Some races break the classes differently to include saw models that don’t get close to the even cube...